Logo

Atrust t68: Disassembly 

Disassembly

As always this is the description of how I got into my t68. It is not necessarily the correct way.

Atrust t68 back panel
Looking at the back panel you can see a screw to the right just above the DVI connector. Remove it.

Atrust t68 back panel removed
Next remove the back panel. Start at the right-hand end. I used a small screwdriver which I inserted in the gap between the DVI socket and the back panel. I used the DVI socket as something to lever against. Having 'popped out' the right hand end, work down to the left hand end.

Atrust t68 base
Next turn the t68 over and remove the two front feet to reveal two screw heads. The feet are held in place with some double-sided sticky tape and can be teased out with a small screwdriver blade.

Undo and remove the two screws.

The bottom of the case is held in place by a number of small plastic catches. I started from the lower left and worked around the case from there. It came off relatively easily without the need for any excessive force.

Atrust t68 circuit board
The final step is to remove the two screws (circled) towards the rear of the of the circuit board. This will let you remove the board from the housing.

As always, reverse the process to put it back together.